Battery charged indicator

General posts about the s1mp3 user interface.

Battery charged indicator

Postby Ler » Tue Jun 05, 2007 9:40 am

Hello all,
I have a MP4 player:
Device Name: S1 Mp3 Player
manufacturer = 'Wilson Co. Ltd.'
Version : 9.0.48
I don't know for which reason the MP4 is not showing the state of charge of the battery when it is charging. is it possible that the display show again the battery indicator? can somebody help me?

Regards Ler
Ler
 
Posts: 3
Joined: Mon Apr 30, 2007 8:34 am

Re: Battery charged indicator

Postby Roch098 » Sat Feb 13, 2010 8:00 am

Golf Carts - Don't get stuck out on the course. Know when to recharge your battery. When the meter starts flashing red and yellow, it is time to recharge the battery.

Boating applications - Many boaters will shut off the engine and continue to operate battery powered equipment such as radios, lights, radar, fish finders, microwave ovens, refrigerators and so on for extended periods of time. This Battery Condition Indicator may be used on any 12 volt DC system with a battery.

* The battery meter has been designed to prevent not being able to start you engine when on the water. Most battery manufacturers consider a battery to be dead when the battery reaches 10.5 volts (for 12 volt batteries). When the battery discharges to 11.89 volts, there will still be approximately 300 cranking amps of power available to start an engine that is in good condition.
* When the battery discharges below this level, it is doubtful that you will be able to start it without a jump start or recharging.
* Battery Status
o The battery meter has 10 LEDS that will light to show the battery condition. When fully charged, only the 10th LED will light shown a green LED.
o As the battery discharges, successively lower LEDs will light; the 9th, 8th, 7th and so on lighting only 1 LED.
o At approximately 12.09 volts, the #3 LED will light and the color is Yellow as a caution indicator.
o At approximately 12.0 volts, the #2 LED will light as a Flashing Yellow.
o When the battery discharges to approximately 11.9 volts, the #1 LED will start FLASHING RED with the #2 LED FLASHING Yellow alternately.

It is recommended to restart you engine when the #3 LED lights Yellow as a safety margin to prevent dead batteries.

* Other: Once an engine has been restarted and the alternator or generator is putting out 13 volts DC or higher, the battery indicator will immediately reset to a fully charged state (10th LED light). It is important to run your engine for at least 20 minutes to recharge the battery.
* After shutting off the engine, it will take approximately 160 seconds between each successive LED to be lit (decreasing) when connected to a fully or partially discharged battery. It can take up to 18 to 19 minutes to re-register the actual voltage it the battery voltage is down to ~12.09 volts or lower.

CAUTION: This is not a full proof device and no warranty is made that your engine will start. The battery voltages indicated above are a consensus of several major battery manufacturers. Faulty ignition systems, starter motors, engines needing a tune-up, bad fuel or other electrical problems may exist that will prevent you from starting the engine even when the battery indicator shows a charge state as high as the 7th LED.

Reading


10 LEDs, #10 being fully charged and #1 being fully discharged

Voltage Indicator Range


12.75 volts Full; 11.89 volts Empty

Weight


2 Ounces

Voltage Supply


12 Volts DC

Temperature Range


-40 to 185 Farenheit; -40C to 85C

Power Consumption


2 Watts

Dimensions


*
OD 2.25"
*
Depth Behind front meter flange to end of mounting screws - 1 7/8 inches
*
Hole size - 2 1/16"






------------------------------------------------------------------------------------------------------------------


RV carports | chinese mobile phones | Colorado mortgage
Roch098
 
Posts: 1
Joined: Sat Feb 13, 2010 7:55 am


Return to General Usability

Who is online

Users browsing this forum: No registered users and 1 guest



cron